razor
#17
(03-10-2013, 09:47 PM)Tony Wells Wrote: I've always been a bit afraid. Of course, this is TV, but they seem always to show the angle of attack nearly 90 degrees, like scraping instead of cutting. Doesn't seem very comfortable, nor a way to get a close shave. What's the real preferred angle?

Hi, I would say the angle I use is about 20-30 degrees or so, you can soon tell,if it's 90 degrees it will just drag so gradually lower the angle till it cuts nicely, as said I've used mine for 40 odd yrs & as stated above it must be sharp,you can only strop for so long then I sharpen on an arkansas stone every few months,once mastered razor blades are a thing of the past.
Graham.
the artfull-codger, proud to be a member of MetalworkingFun Forum since Feb 2013.
Reply
Thanks given by:


Messages In This Thread
razor - by dallen - 12-23-2012, 08:01 PM
RE: razor - by sasquatch - 12-23-2012, 08:22 PM
RE: razor - by dallen - 12-23-2012, 08:32 PM
RE: razor - by dallen - 12-25-2012, 01:04 PM
RE: razor - by dallen - 12-26-2012, 08:25 AM
RE: razor - by the artfull-codger - 02-25-2013, 04:52 PM
RE: razor - by dallen - 02-27-2013, 02:10 PM
RE: razor - by TomG - 02-28-2013, 08:15 AM
RE: razor - by mattinker - 03-01-2013, 11:57 AM
RE: razor - by dallen - 02-28-2013, 01:49 PM
RE: razor - by dallen - 02-28-2013, 04:02 PM
RE: razor - by TomG - 02-28-2013, 05:52 PM
RE: razor - by TomG - 03-01-2013, 01:28 PM
RE: razor - by dallen - 03-01-2013, 01:37 PM
RE: razor - by Tony Wells - 03-10-2013, 09:47 PM
RE: razor - by the artfull-codger - 03-15-2013, 03:21 PM
RE: razor - by dallen - 03-11-2013, 08:50 PM
RE: razor - by Tony Wells - 03-15-2013, 09:33 PM
RE: razor - by DaveH - 03-16-2013, 02:53 PM
RE: razor - by Tony Wells - 03-18-2013, 08:46 AM
RE: razor - by dallen - 03-22-2013, 03:59 PM
RE: razor - by TomG - 03-23-2013, 02:47 PM
RE: razor - by EdK - 03-23-2013, 02:49 PM
RE: razor - by TomG - 03-23-2013, 03:00 PM
RE: razor - by EdK - 03-23-2013, 03:36 PM
RE: razor - by TomG - 03-23-2013, 03:59 PM
RE: razor - by dallen - 03-23-2013, 05:12 PM
RE: razor - by EdK - 03-23-2013, 05:15 PM
RE: razor - by dallen - 03-23-2013, 05:49 PM
RE: razor - by EdK - 03-23-2013, 07:14 PM



Users browsing this thread: 4 Guest(s)