03-05-2013, 08:14 PM
It might be as simple as the lead screw moving, should be an adjustment in the bearings to take up the slack.
Free advice is worth exactly what you payed for it.
Greg
Greg
|
Lathe DRO
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: Lathe DRO - by f350ca - 03-05-2013, 10:09 AM
RE: Lathe DRO - by EdK - 03-05-2013, 11:00 AM
RE: Lathe DRO - by lemelman - 03-11-2013, 03:08 AM
RE: Lathe DRO - by Mayhem - 03-05-2013, 10:17 AM
RE: Lathe DRO - by f350ca - 03-05-2013, 03:15 PM
RE: Lathe DRO - by EdK - 03-05-2013, 06:27 PM
RE: Lathe DRO - by EdK - 03-05-2013, 06:50 PM
RE: Lathe DRO - by PixMan - 03-05-2013, 05:57 PM
RE: Lathe DRO - by EdK - 03-05-2013, 06:29 PM
RE: Lathe DRO - by f350ca - 03-05-2013, 08:14 PM
RE: Lathe DRO - by Dave J - 03-05-2013, 10:34 PM
RE: Lathe DRO - by EdK - 03-06-2013, 07:08 AM
RE: Lathe DRO - by stevec - 03-06-2013, 07:33 AM
RE: Lathe DRO - by EdK - 03-06-2013, 10:08 AM
RE: Lathe DRO - by Dave J - 03-06-2013, 09:10 PM
RE: Lathe DRO - by EdK - 03-07-2013, 06:14 AM
RE: Lathe DRO - by Dave J - 03-06-2013, 09:17 PM
RE: Lathe DRO - by Dave J - 03-07-2013, 06:37 AM
RE: Lathe DRO - by EdK - 03-07-2013, 08:43 AM
RE: Lathe DRO - by Mayhem - 03-07-2013, 08:31 AM
RE: Lathe DRO - by PixMan - 03-07-2013, 11:01 PM
RE: Lathe DRO - by EdK - 03-08-2013, 06:50 AM
|
Users browsing this thread: 3 Guest(s)