MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lathe DRO

Thread Modes
Lathe DRO
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#7
03-05-2013, 06:27 PM
(03-05-2013, 03:15 PM)f350ca Wrote: Can you make the dro change by pushing and pulling on the cross slide?

I tried moving the cross slide by hand to see if I could feel any movement but did not have the DRO turned on at the time. I'll try it with it turned on and see what happens.

Ed
Reply
Thanks given by:


Messages In This Thread
Lathe DRO - by EdK - 03-05-2013, 09:23 AM
RE: Lathe DRO - by f350ca - 03-05-2013, 10:09 AM
RE: Lathe DRO - by EdK - 03-05-2013, 11:00 AM
RE: Lathe DRO - by lemelman - 03-11-2013, 03:08 AM
RE: Lathe DRO - by Mayhem - 03-05-2013, 10:17 AM
RE: Lathe DRO - by f350ca - 03-05-2013, 03:15 PM
RE: Lathe DRO - by EdK - 03-05-2013, 06:27 PM
RE: Lathe DRO - by EdK - 03-05-2013, 06:50 PM
RE: Lathe DRO - by PixMan - 03-05-2013, 05:57 PM
RE: Lathe DRO - by EdK - 03-05-2013, 06:29 PM
RE: Lathe DRO - by f350ca - 03-05-2013, 08:14 PM
RE: Lathe DRO - by Dave J - 03-05-2013, 10:34 PM
RE: Lathe DRO - by EdK - 03-06-2013, 07:08 AM
RE: Lathe DRO - by stevec - 03-06-2013, 07:33 AM
RE: Lathe DRO - by EdK - 03-06-2013, 10:08 AM
RE: Lathe DRO - by Dave J - 03-06-2013, 09:10 PM
RE: Lathe DRO - by EdK - 03-07-2013, 06:14 AM
RE: Lathe DRO - by Dave J - 03-06-2013, 09:17 PM
RE: Lathe DRO - by Dave J - 03-07-2013, 06:37 AM
RE: Lathe DRO - by EdK - 03-07-2013, 08:43 AM
RE: Lathe DRO - by Mayhem - 03-07-2013, 08:31 AM
RE: Lathe DRO - by PixMan - 03-07-2013, 11:01 PM
RE: Lathe DRO - by EdK - 03-08-2013, 06:50 AM



Users browsing this thread: 4 Guest(s)