The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Lathe DRO

Thread Modes
Lathe DRO
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#1
03-05-2013, 09:23 AM
Is is normal for the cross slide to move a few thousands when you engage the power feed? I was using the DRO to cut the blank for the metric thread I was cutting and noticed that the cross slide would advance a few thousands whenever I engaged the power feed.

Ed
Reply
Thanks given by:


Messages In This Thread
Lathe DRO - by EdK - 03-05-2013, 09:23 AM
RE: Lathe DRO - by f350ca - 03-05-2013, 10:09 AM
RE: Lathe DRO - by EdK - 03-05-2013, 11:00 AM
RE: Lathe DRO - by lemelman - 03-11-2013, 03:08 AM
RE: Lathe DRO - by Mayhem - 03-05-2013, 10:17 AM
RE: Lathe DRO - by f350ca - 03-05-2013, 03:15 PM
RE: Lathe DRO - by EdK - 03-05-2013, 06:27 PM
RE: Lathe DRO - by EdK - 03-05-2013, 06:50 PM
RE: Lathe DRO - by PixMan - 03-05-2013, 05:57 PM
RE: Lathe DRO - by EdK - 03-05-2013, 06:29 PM
RE: Lathe DRO - by f350ca - 03-05-2013, 08:14 PM
RE: Lathe DRO - by Dave J - 03-05-2013, 10:34 PM
RE: Lathe DRO - by EdK - 03-06-2013, 07:08 AM
RE: Lathe DRO - by stevec - 03-06-2013, 07:33 AM
RE: Lathe DRO - by EdK - 03-06-2013, 10:08 AM
RE: Lathe DRO - by Dave J - 03-06-2013, 09:10 PM
RE: Lathe DRO - by EdK - 03-07-2013, 06:14 AM
RE: Lathe DRO - by Dave J - 03-06-2013, 09:17 PM
RE: Lathe DRO - by Dave J - 03-07-2013, 06:37 AM
RE: Lathe DRO - by EdK - 03-07-2013, 08:43 AM
RE: Lathe DRO - by Mayhem - 03-07-2013, 08:31 AM
RE: Lathe DRO - by PixMan - 03-07-2013, 11:01 PM
RE: Lathe DRO - by EdK - 03-08-2013, 06:50 AM



Users browsing this thread: 5 Guest(s)