MetalworkingFun Forum › Machining › General Metalworking Discussion v
How to slow down power feed?

Thread Modes
How to slow down power feed?
Wongster Offline
Junior
****
Posts: 301
Threads: 30
Joined: Mar 2012
Location: Singapore
#7
03-31-2012, 09:30 AM
Ed,

You are right. It's the 2MT arbor with a supposedly soft end from the Hemingay kit. I'll swap in the indexable tool with has a radius tip. Lots of smoke with lots of oil.... Freaked wife out.

Regards,
Wong
Wongster
http://www.wongstersproduction.com

Proud to be a member of MetalworkingFun Forum since Mar 2012.
Reply
Thanks given by:


Messages In This Thread
How to slow down power feed? - by Wongster - 03-30-2012, 07:40 AM
RE: How to slow down power feed? - by EdK - 03-30-2012, 08:07 AM
RE: How to slow down power feed? - by Wongster - 03-30-2012, 09:21 AM
RE: How to slow down power feed? - by EdK - 03-30-2012, 10:23 AM
RE: How to slow down power feed? - by Wongster - 03-30-2012, 10:52 PM
RE: How to slow down power feed? - by EdK - 03-31-2012, 09:05 AM
RE: How to slow down power feed? - by Wongster - 03-31-2012, 09:30 AM
RE: How to slow down power feed? - by Bogstandard - 04-01-2012, 05:25 AM
RE: How to slow down power feed? - by Wongster - 04-01-2012, 07:29 AM
RE: How to slow down power feed? - by DaveH - 04-01-2012, 08:56 AM
RE: How to slow down power feed? - by Wongster - 04-01-2012, 09:49 AM
RE: How to slow down power feed? - by EdK - 04-01-2012, 10:06 AM
RE: How to slow down power feed? - by Wongster - 04-01-2012, 10:34 AM
RE: How to slow down power feed? - by EdK - 04-01-2012, 01:15 PM
RE: How to slow down power feed? - by DaveH - 04-01-2012, 11:05 AM
RE: How to slow down power feed? - by Wongster - 04-01-2012, 11:26 AM



Users browsing this thread: 1 Guest(s)