03-03-2013, 07:15 PM
(03-03-2013, 05:02 PM)sasquatch Wrote: I always loved big thick washers like that, no idea why, i guess cause they just seem heavy duty or?
Where are the set screws you mention?
The set screws are what holds the washer for turning. I could have turned down the bar stock and threaded it for a nut to hold the plate but this arbor just used 2 long set screws tapped into it. Then the arbor is placed in the chuck and the plate is bolted onto the arbor and held with a live center...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...