I pulled the razor apart that I posted a photo of yesterday and this is what I found besides there being cracks in the handle scales that I hope someone can tell me how to stabalize not real sure of a good way to do it, thinking putting it in some polyurethane and pulling a vacuum on them not sure it it would pull the stuff into the cracks or not.
some of the cracks
the other problem is this great big gapping hole that is suppose to have a pin in the size of the rod that is in the photo with the razor tail, my thoughts are to install the bushing I have made which is on the pin material. Question I have is do I solder it in or let it spin. problem with the hole is it isn't round looks like it was made with a square punch.
any suggestions.
some of the cracks
the other problem is this great big gapping hole that is suppose to have a pin in the size of the rod that is in the photo with the razor tail, my thoughts are to install the bushing I have made which is on the pin material. Question I have is do I solder it in or let it spin. problem with the hole is it isn't round looks like it was made with a square punch.
any suggestions.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!