|
Holding small work pieces
|
03-30-2012, 10:32 PM
(03-30-2012, 10:14 PM)EdAK Wrote: I see I've got a lot to learn, and that's OK. Ed, Don't we all???  Do you have an angle plate set? If so, square up your part in the little vice first. Then just set your chosen angle plate in the bottom of your larger vice. Place the small vice on top of the angle plate and tighten down the large vice jaws. Then your work is already set to cut the angle you need. 
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Holding small work pieces - by DaveH - 03-08-2012, 02:38 PM
RE: Holding small work pieces - by EdK - 03-08-2012, 04:48 PM
RE: Holding small work pieces - by B34VD - 03-11-2012, 05:51 PM
RE: Holding small work pieces - by Bogstandard - 03-30-2012, 02:08 AM
RE: Holding small work pieces - by EdK - 03-30-2012, 07:10 AM
RE: Holding small work pieces - by DaveH - 03-30-2012, 08:57 PM
RE: Holding small work pieces - by Highpower - 03-30-2012, 10:11 PM
RE: Holding small work pieces - by EdK - 03-30-2012, 10:14 PM
RE: Holding small work pieces - by Highpower - 03-30-2012, 10:32 PM
RE: Holding small work pieces - by EdK - 03-31-2012, 08:39 AM
RE: Holding small work pieces - by Wongster - 03-30-2012, 11:03 PM
RE: Holding small work pieces - by DaveH - 03-31-2012, 10:17 AM
RE: Holding small work pieces - by Highpower - 04-01-2012, 11:56 AM
RE: Holding small work pieces - by Wongster - 03-31-2012, 10:47 PM
RE: Holding small work pieces - by DaveH - 04-01-2012, 02:45 AM
RE: Holding small work pieces - by ToolCat - 04-01-2012, 09:23 PM
RE: Holding small work pieces - by DaveH - 04-01-2012, 11:24 PM
RE: Holding small work pieces - by krv3000 - 04-02-2012, 02:16 AM
|
