Funny you should mention that Tom - I have a ram's skull outside in which I did the very same thing. I hooked them up to the solar panel from a garden light and I must admit it does look quite good. I did think about drilling a hole in a ping pong ball and popping them in the eye socket but haven't gotten that far yet.
Mick - that is looking the part and you have done an exceptional job.
A couple of suggestions that may be of use: the fusion lines could be done with a scalpel and a steady hand but the lines need to have a little more zig-zag to them. You could also add a little more 'point' to the canine teeth. A rotary burr would be ideal for the fine shaping but probably not "carving" in the traditional/classic sense.
Mick - that is looking the part and you have done an exceptional job.
A couple of suggestions that may be of use: the fusion lines could be done with a scalpel and a steady hand but the lines need to have a little more zig-zag to them. You could also add a little more 'point' to the canine teeth. A rotary burr would be ideal for the fine shaping but probably not "carving" in the traditional/classic sense.
Hunting American dentists since 2015.