advice on moving south bend mill

[EdK]

(02-21-2013, 11:33 AM)monkers Wrote: Aslo, has anyone modified 30nmt tapers to fit this 30mm spindle? They would need to have the set screw pockets cut into them, trying to figure out the best way to do that, curious if anyone has a jig or fixture set up for this, or photos....Thanks

monkers,

I'm not sure what you're referring to here. What is a 30nmt taper spindle and what is a 30mm spindle?

I suspect you meant a NMTB 30 spindle but I have no idea what a 30mm spindle is.

Ed