02-21-2013, 01:33 PM
If there is one thing I have learned over the years I have been building and repairing small engines is that you have to be prepared to stop an make a special holding fixture at any time.
The center main bearing shaft needs to be square on both ends. It is only 1.5 inches long. I made this holder to hold if fast in the vise. Just cut and turn till both sides are .375X.375.
"Billy G"
The center main bearing shaft needs to be square on both ends. It is only 1.5 inches long. I made this holder to hold if fast in the vise. Just cut and turn till both sides are .375X.375.
"Billy G"