How to slow down power feed?

Hello There, Guest! Register

Thread Modes

How to slow down power feed?

Wongster Offline

Offline

Junior

Posts: 301
Threads: 30
Joined: Mar 2012
Location: Singapore

#3

03-30-2012, 09:21 AM

Ed,

Z1 = 20/60
Z2 = 70/25
L = -/75

For the faster speed of 0.14mm/rev, Z1 = 40/60.

Regards,
Wong

Wongster
http://www.wongstersproduction.com

Proud to be a member of MetalworkingFun Forum since Mar 2012.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

How to slow down power feed? - by Wongster - 03-30-2012, 07:40 AM

RE: How to slow down power feed? - by EdK - 03-30-2012, 08:07 AM

RE: How to slow down power feed? - by Wongster - 03-30-2012, 09:21 AM

RE: How to slow down power feed? - by EdK - 03-30-2012, 10:23 AM

RE: How to slow down power feed? - by Wongster - 03-30-2012, 10:52 PM

RE: How to slow down power feed? - by EdK - 03-31-2012, 09:05 AM

RE: How to slow down power feed? - by Wongster - 03-31-2012, 09:30 AM

RE: How to slow down power feed? - by Bogstandard - 04-01-2012, 05:25 AM

RE: How to slow down power feed? - by Wongster - 04-01-2012, 07:29 AM

RE: How to slow down power feed? - by DaveH - 04-01-2012, 08:56 AM

RE: How to slow down power feed? - by Wongster - 04-01-2012, 09:49 AM

RE: How to slow down power feed? - by EdK - 04-01-2012, 10:06 AM

RE: How to slow down power feed? - by Wongster - 04-01-2012, 10:34 AM

RE: How to slow down power feed? - by EdK - 04-01-2012, 01:15 PM

RE: How to slow down power feed? - by DaveH - 04-01-2012, 11:05 AM

RE: How to slow down power feed? - by Wongster - 04-01-2012, 11:26 AM

Users browsing this thread: 2 Guest(s)