|
4 inch 4 jaw chuck
|
02-20-2013, 07:31 AM
(02-19-2013, 09:01 PM)dallen Wrote: poured the backing plate today, whats funny is the metal went in the furnace yellow as gold and came out of the mold looking a lot like copper and the stuff I used was all the same color and not a bit of copper in it. I always thought bronze and/or brass were alloys containing copper?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
4 inch 4 jaw chuck - by dallen - 02-15-2013, 09:56 PM
RE: 4 inch 4 jaw chuck - by doubleboost - 02-16-2013, 04:33 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-16-2013, 04:47 PM
RE: 4 inch 4 jaw chuck - by doubleboost - 02-16-2013, 04:52 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-16-2013, 07:59 PM
RE: 4 inch 4 jaw chuck - by doubleboost - 02-16-2013, 08:09 PM
RE: 4 inch 4 jaw chuck - by stevec - 02-16-2013, 08:27 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-17-2013, 11:44 AM
RE: 4 inch 4 jaw chuck - by dallen - 02-18-2013, 01:22 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-19-2013, 09:01 PM
RE: 4 inch 4 jaw chuck - by stevec - 02-20-2013, 07:31 AM
RE: 4 inch 4 jaw chuck - by dallen - 02-20-2013, 09:37 AM
RE: 4 inch 4 jaw chuck - by EdK - 02-20-2013, 11:53 AM
RE: 4 inch 4 jaw chuck - by dallen - 02-20-2013, 03:48 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-28-2013, 05:15 PM
|
