|
Holding small work pieces
|
|
03-30-2012, 02:08 AM
These little vices are great for holding small pieces, I've got the 25mm (1") version of the first ones on this page, and I just sit it in my normal milling vice on a pair of parallels.
http://www.arceurotrade.co.uk/Catalogue/...hine-Vices You can then swing about even large cutters with no problems at all. ![[Image: Swingup44.jpg]](http://i202.photobucket.com/albums/aa102/bogstandard_photos/Swingup44.jpg) John |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Holding small work pieces - by DaveH - 03-08-2012, 02:38 PM
RE: Holding small work pieces - by EdK - 03-08-2012, 04:48 PM
RE: Holding small work pieces - by B34VD - 03-11-2012, 05:51 PM
RE: Holding small work pieces - by Bogstandard - 03-30-2012, 02:08 AM
RE: Holding small work pieces - by EdK - 03-30-2012, 07:10 AM
RE: Holding small work pieces - by DaveH - 03-30-2012, 08:57 PM
RE: Holding small work pieces - by Highpower - 03-30-2012, 10:11 PM
RE: Holding small work pieces - by EdK - 03-30-2012, 10:14 PM
RE: Holding small work pieces - by Highpower - 03-30-2012, 10:32 PM
RE: Holding small work pieces - by EdK - 03-31-2012, 08:39 AM
RE: Holding small work pieces - by Wongster - 03-30-2012, 11:03 PM
RE: Holding small work pieces - by DaveH - 03-31-2012, 10:17 AM
RE: Holding small work pieces - by Highpower - 04-01-2012, 11:56 AM
RE: Holding small work pieces - by Wongster - 03-31-2012, 10:47 PM
RE: Holding small work pieces - by DaveH - 04-01-2012, 02:45 AM
RE: Holding small work pieces - by ToolCat - 04-01-2012, 09:23 PM
RE: Holding small work pieces - by DaveH - 04-01-2012, 11:24 PM
RE: Holding small work pieces - by krv3000 - 04-02-2012, 02:16 AM
|
