|
4 inch 4 jaw chuck
|
02-17-2013, 11:44 AM
pattern with a couple coats of rattle can paint and the just added wax fillet, co a couple more coats of paint and I should be ready to pour tomorrow afternoon for sure Tuesday morning but may wait till Wenesday when my coffee drinking buddy shows up.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
4 inch 4 jaw chuck - by dallen - 02-15-2013, 09:56 PM
RE: 4 inch 4 jaw chuck - by doubleboost - 02-16-2013, 04:33 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-16-2013, 04:47 PM
RE: 4 inch 4 jaw chuck - by doubleboost - 02-16-2013, 04:52 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-16-2013, 07:59 PM
RE: 4 inch 4 jaw chuck - by doubleboost - 02-16-2013, 08:09 PM
RE: 4 inch 4 jaw chuck - by stevec - 02-16-2013, 08:27 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-17-2013, 11:44 AM
RE: 4 inch 4 jaw chuck - by dallen - 02-18-2013, 01:22 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-19-2013, 09:01 PM
RE: 4 inch 4 jaw chuck - by stevec - 02-20-2013, 07:31 AM
RE: 4 inch 4 jaw chuck - by dallen - 02-20-2013, 09:37 AM
RE: 4 inch 4 jaw chuck - by EdK - 02-20-2013, 11:53 AM
RE: 4 inch 4 jaw chuck - by dallen - 02-20-2013, 03:48 PM
RE: 4 inch 4 jaw chuck - by dallen - 02-28-2013, 05:15 PM
|
