02-13-2013, 03:55 PM
Greg,
Multiply the diameter of your part by PI and divide by the tooth spacing of the knurl (1/pitch). If the result is close to a whole number you are good to go, otherwise, tweak the diameter until it is. As I said though, it's not very critical unless you are using a knurl with a very coarse pitch.
Tom
Multiply the diameter of your part by PI and divide by the tooth spacing of the knurl (1/pitch). If the result is close to a whole number you are good to go, otherwise, tweak the diameter until it is. As I said though, it's not very critical unless you are using a knurl with a very coarse pitch.
Tom
![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png)