been a while since i last posted and update on the knurler that I made. Anyway I finally got around to ordering some smaller knurls for it and got them installed today, seeing as how they are 1/2 X 3/16 X 3/16 hole I had to make new shanks for them so i cut up a couple more brazed on carbide lathe tools for the shanks. and milled a slot and put in the pin hole.
Anyway heres the photo, pins are too long but due to weather I didn't get out and go get shorter ones but will change them in a day or two, or I may just leave them like they are.
But I may make a larger one with a bigger bore for doing things bigger then what will fit into this one.
Anyway heres the photo, pins are too long but due to weather I didn't get out and go get shorter ones but will change them in a day or two, or I may just leave them like they are.
But I may make a larger one with a bigger bore for doing things bigger then what will fit into this one.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!