02-06-2013, 11:57 PM
Looking Good. What pitch are the ball screws? With the steppers connected directly what will the smallest movement you can make be?
Free advice is worth exactly what you payed for it.
Greg
Greg
|
X2 CNC Conversion
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
X2 CNC Conversion - by Hawkeye - 01-22-2013, 12:40 AM
RE: X2 CNC Conversion - by Mayhem - 01-22-2013, 08:08 AM
RE: X2 CNC Conversion - by DaveH - 01-22-2013, 01:22 PM
RE: X2 CNC Conversion - by Hawkeye - 01-22-2013, 09:38 PM
RE: X2 CNC Conversion - by Hawkeye - 01-31-2013, 11:48 PM
RE: X2 CNC Conversion - by starlight_tools - 02-06-2013, 07:56 PM
RE: X2 CNC Conversion - by Hawkeye - 02-06-2013, 11:04 PM
RE: X2 CNC Conversion - by f350ca - 02-06-2013, 11:57 PM
RE: X2 CNC Conversion - by Hawkeye - 02-07-2013, 09:26 PM
RE: X2 CNC Conversion - by f350ca - 02-07-2013, 11:04 PM
RE: X2 CNC Conversion - by Hawkeye - 02-08-2013, 10:35 PM
RE: X2 CNC Conversion - by dallen - 02-15-2013, 10:06 PM
RE: X2 CNC Conversion - by Hawkeye - 02-17-2013, 11:07 AM
RE: X2 CNC Conversion - by Hawkeye - 09-30-2017, 10:56 PM
RE: X2 CNC Conversion - by rleete - 11-12-2020, 10:51 AM
RE: X2 CNC Conversion - by Hawkeye - 11-12-2020, 11:38 PM
|
Users browsing this thread: 4 Guest(s)