Carbide tool grinders.
#18
(02-02-2013, 01:01 PM)arvidj Wrote: Do you have a recommended grit or grits for an Aluminum Oxide wheel for HSS bits?

Arvid, I am using a 46 grit wheel on the grinder for roughing out HSS tool blanks. And even that seems to take forever. Angel

   

For finishing and touch-up I use my belt sander which usually has a 180 grit belt on it. I have finer grit belts as well but they never seem to make it onto the grinder. Blush

If I had the room and the money, I would have a second grinder with finer wheels instead. Happyyes

The green wheels that came with my grinder looked like they were made from the stuff that gets washed out of a cement mixer at the end of the day, with a little Krylon thrown on for color. Blink
Those went straight from the box to the trash can.
Willie
Reply
Thanks given by:


Messages In This Thread
Carbide tool grinders. - by Highpower - 04-11-2012, 12:58 PM
RE: Carbide tool grinders. - by DaveH - 04-11-2012, 01:51 PM
RE: Carbide tool grinders. - by TOM REED - 04-11-2012, 02:47 PM
RE: Carbide tool grinders. - by Highpower - 04-11-2012, 04:15 PM
RE: Carbide tool grinders. - by EdK - 04-11-2012, 05:04 PM
RE: Carbide tool grinders. - by Highpower - 04-11-2012, 08:52 PM
RE: Carbide tool grinders. - by arvidj - 04-11-2012, 09:33 PM
RE: Carbide tool grinders. - by arvidj - 02-01-2013, 11:35 PM
RE: Carbide tool grinders. - by Highpower - 02-02-2013, 12:38 AM
RE: Carbide tool grinders. - by arvidj - 02-02-2013, 11:24 AM
RE: Carbide tool grinders. - by stevec - 02-02-2013, 10:56 AM
RE: Carbide tool grinders. - by Highpower - 02-02-2013, 11:06 AM
RE: Carbide tool grinders. - by Highpower - 02-02-2013, 11:44 AM
RE: Carbide tool grinders. - by arvidj - 02-02-2013, 01:01 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 12:26 PM
RE: Carbide tool grinders. - by stevec - 02-02-2013, 02:12 PM
RE: Carbide tool grinders. - by sasquatch - 02-02-2013, 04:29 PM
RE: Carbide tool grinders. - by EdK - 02-02-2013, 05:54 PM
RE: Carbide tool grinders. - by EdK - 02-04-2013, 12:30 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 01:29 PM
RE: Carbide tool grinders. - by EdK - 02-04-2013, 01:38 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 01:49 PM
RE: Carbide tool grinders. - by f350ca - 02-04-2013, 01:44 PM
RE: Carbide tool grinders. - by Highpower - 02-04-2013, 01:51 PM



Users browsing this thread: 2 Guest(s)