MetalworkingFun Forum › Machining › General Metalworking Discussion v
Workholding on the lathe

Thread Modes
Workholding on the lathe
Wongster Offline
Junior
****
Posts: 301
Threads: 30
Joined: Mar 2012
Location: Singapore
#16
03-28-2012, 10:08 AM
Hi Dave,

I'll report back when I'm on it. Will get the Set-Over Centre out of the way. 2 more parts: 1) the 2 adjustments screws and 2) machining the end of the 2MT arbor.

Regards,
Wong
Wongster
http://www.wongstersproduction.com

Proud to be a member of MetalworkingFun Forum since Mar 2012.
Reply
Thanks given by:


Messages In This Thread
Workholding on the lathe - by Wongster - 03-27-2012, 06:28 PM
RE: Workholding on the lathe - by aametalmaster - 03-27-2012, 06:34 PM
RE: Workholding on the lathe - by Wongster - 03-27-2012, 06:55 PM
RE: Workholding on the lathe - by aametalmaster - 03-27-2012, 07:27 PM
RE: Workholding on the lathe - by aametalmaster - 03-27-2012, 07:33 PM
RE: Workholding on the lathe - by DaveH - 03-27-2012, 08:57 PM
RE: Workholding on the lathe - by Wongster - 03-27-2012, 09:54 PM
RE: Workholding on the lathe - by Wongster - 03-28-2012, 12:25 AM
RE: Workholding on the lathe - by EdK - 03-28-2012, 06:37 AM
RE: Workholding on the lathe - by Wongster - 03-28-2012, 07:04 AM
RE: Workholding on the lathe - by DaveH - 03-28-2012, 08:05 AM
RE: Workholding on the lathe - by Wongster - 03-28-2012, 09:01 AM
RE: Workholding on the lathe - by DaveH - 03-28-2012, 09:16 AM
RE: Workholding on the lathe - by Mayhem - 03-28-2012, 09:37 AM
RE: Workholding on the lathe - by DaveH - 03-28-2012, 09:48 AM
RE: Workholding on the lathe - by Wongster - 03-28-2012, 10:08 AM



Users browsing this thread: 2 Guest(s)