Workholding on the lathe

Hello There, Guest! Register

Thread Modes

Workholding on the lathe

Mayhem Offline

Offline

purveyor of mischief

Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia

#14

03-28-2012, 09:37 AM

Dave - is that an 80 degree centre you are using in your sketch?

Hunting American dentists since 2015.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Workholding on the lathe - by Wongster - 03-27-2012, 06:28 PM

RE: Workholding on the lathe - by aametalmaster - 03-27-2012, 06:34 PM

RE: Workholding on the lathe - by Wongster - 03-27-2012, 06:55 PM

RE: Workholding on the lathe - by aametalmaster - 03-27-2012, 07:27 PM

RE: Workholding on the lathe - by aametalmaster - 03-27-2012, 07:33 PM

RE: Workholding on the lathe - by DaveH - 03-27-2012, 08:57 PM

RE: Workholding on the lathe - by Wongster - 03-27-2012, 09:54 PM

RE: Workholding on the lathe - by Wongster - 03-28-2012, 12:25 AM

RE: Workholding on the lathe - by EdK - 03-28-2012, 06:37 AM

RE: Workholding on the lathe - by Wongster - 03-28-2012, 07:04 AM

RE: Workholding on the lathe - by DaveH - 03-28-2012, 08:05 AM

RE: Workholding on the lathe - by Wongster - 03-28-2012, 09:01 AM

RE: Workholding on the lathe - by DaveH - 03-28-2012, 09:16 AM

RE: Workholding on the lathe - by Mayhem - 03-28-2012, 09:37 AM

RE: Workholding on the lathe - by DaveH - 03-28-2012, 09:48 AM

RE: Workholding on the lathe - by Wongster - 03-28-2012, 10:08 AM

Users browsing this thread: 4 Guest(s)