ER32 Adapter(purchased)

[b4dyc]

Hi again,
I am having problems working out if this ER32 adapter (for myford nose) is good or bad as i have never used one before?
Anyway, I took a video on my phone and put it on photobucket so it can be seen.
I started by showing my lathes run out, which looks okay? then moved onto the run out of the external parts of the adapter (i guess not too important?) but there seems to be more errors. Then i popped a bit of silver steel into the collet (installed properly by clicking into the nut first) tightened up with the spanner and can see a lot of error there.
I then popped my 3 jaw chuck in and had far less errors?
It looks crap to me, but I am not really sure if i have overlooked anything
Movie here if any one cares to look



Thanks