03-27-2012, 07:27 PM
Well you could drill the center in the drillpress and turn it on an arbor that is chucked in the chuck and the other end of the arbor is held in a live center. Then turn a spigot that you can chuck up in your chuck. Then face the other side once its chucked up. Been there...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...