mill/drill table oiling upgrades?
#14
I like the way my old Brown&Sharpe does it - there are flathead screws flush mounted on the table top (marked "oil"). Unscrew them and fill with oil. Those ball oilers don't vent air like they should.
Reply
Thanks given by:


Messages In This Thread
mill/drill table oiling upgrades? - by monkers - 01-23-2013, 10:35 PM
RE: mill/drill table oiling upgrades? - by Mayhem - 01-24-2013, 07:06 AM
RE: mill/drill table oiling upgrades? - by EdK - 01-24-2013, 07:33 AM
RE: mill/drill table oiling upgrades? - by DanH - 01-25-2013, 08:15 PM
RE: mill/drill table oiling upgrades? - by Brian - 01-26-2013, 04:46 PM
RE: mill/drill table oiling upgrades? - by EdK - 01-27-2013, 09:29 AM
RE: mill/drill table oiling upgrades? - by Sunset Machine - 01-27-2013, 09:38 AM
RE: mill/drill table oiling upgrades? - by stevec - 01-27-2013, 09:44 AM
RE: mill/drill table oiling upgrades? - by EdK - 01-30-2013, 05:53 PM
RE: mill/drill table oiling upgrades? - by stevec - 01-31-2013, 08:10 AM
RE: mill/drill table oiling upgrades? - by EdK - 01-31-2013, 08:21 AM



Users browsing this thread: 1 Guest(s)