MetalworkingFun Forum › Machining › General Metalworking Discussion v
Head Studs

Thread Modes
Head Studs
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#12
03-27-2012, 06:39 PM
We have CAT engines at work with over 6,000 HP and cost over a million bucks. My brother in law works at Cat in the parts dept. My mom retired from there. I was too stupid to get a job there...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Head Studs - by TOM REED - 03-18-2012, 08:48 AM
RE: HEAD STUDS - by PixMan - 03-18-2012, 11:39 AM
RE: HEAD STUDS - by B34VD - 03-18-2012, 02:40 PM
RE: HEAD STUDS - by ETC57 - 03-18-2012, 04:30 PM
RE: HEAD STUDS - by TOM REED - 03-18-2012, 09:08 PM
RE: HEAD STUDS - by B34VD - 03-19-2012, 03:17 AM
RE: HEAD STUDS - by TOM REED - 03-19-2012, 05:22 AM
RE: HEAD STUDS - by B34VD - 03-19-2012, 07:04 AM
RE: HEAD STUDS - by TOM REED - 03-19-2012, 01:18 PM
RE: HEAD STUDS - by B34VD - 03-19-2012, 03:26 PM
RE: HEAD STUDS - by krv3000 - 03-20-2012, 09:20 AM
RE: HEAD STUDS - by aametalmaster - 03-27-2012, 06:39 PM
RE: HEAD STUDS - by TOM REED - 03-28-2012, 01:00 AM
RE: HEAD STUDS - by TOM REED - 04-03-2012, 06:23 PM
RE: HEAD STUDS - by EdK - 04-03-2012, 06:40 PM
RE: HEAD STUDS - by TOM REED - 04-04-2012, 02:14 AM
RE: HEAD STUDS - by EdK - 04-04-2012, 06:42 AM
RE: HEAD STUDS - by Highpower - 04-04-2012, 06:57 AM



Users browsing this thread: 6 Guest(s)