Workholding on the lathe

Hello There, Guest! Register

Thread Modes

Workholding on the lathe

aametalmaster Offline

Offline

MTLMSTR

Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio

#2

03-27-2012, 06:34 PM

Well since i have made an ER40 collet chuck i would face one side and bolt it to whatever you are going to run it on and then finish the rest...Bob

Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Workholding on the lathe - by Wongster - 03-27-2012, 06:28 PM

RE: Workholding on the lathe - by aametalmaster - 03-27-2012, 06:34 PM

RE: Workholding on the lathe - by Wongster - 03-27-2012, 06:55 PM

RE: Workholding on the lathe - by aametalmaster - 03-27-2012, 07:27 PM

RE: Workholding on the lathe - by aametalmaster - 03-27-2012, 07:33 PM

RE: Workholding on the lathe - by DaveH - 03-27-2012, 08:57 PM

RE: Workholding on the lathe - by Wongster - 03-27-2012, 09:54 PM

RE: Workholding on the lathe - by Wongster - 03-28-2012, 12:25 AM

RE: Workholding on the lathe - by EdK - 03-28-2012, 06:37 AM

RE: Workholding on the lathe - by Wongster - 03-28-2012, 07:04 AM

RE: Workholding on the lathe - by DaveH - 03-28-2012, 08:05 AM

RE: Workholding on the lathe - by Wongster - 03-28-2012, 09:01 AM

RE: Workholding on the lathe - by DaveH - 03-28-2012, 09:16 AM

RE: Workholding on the lathe - by Mayhem - 03-28-2012, 09:37 AM

RE: Workholding on the lathe - by DaveH - 03-28-2012, 09:48 AM

RE: Workholding on the lathe - by Wongster - 03-28-2012, 10:08 AM

Users browsing this thread: 2 Guest(s)