Tightening a 3-Jaw Chuck

Hello There, Guest! Register

Thread Modes

Tightening a 3-Jaw Chuck

PixMan Offline

Offline

Resident Pariah

Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA

#13

01-24-2013, 06:28 PM (This post was last modified: 01-24-2013, 06:28 PM by PixMan.)

I have a Pratt-Burnerd Super Precision 3-jaw scroll chuck on my dad's lathe. I got it for $200 from a Harrison lathe distributor who had dropped it and damaged one of the top jaws.

It runs out less than .0005" no matter which of the 3 holes I use. Big Grin

Big Grin

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 01:38 PM

RE: Tightening a 3-Jaw Chuck - by Highpower - 01-24-2013, 02:18 PM

RE: Tightening a 3-Jaw Chuck - by stevec - 01-24-2013, 02:47 PM

RE: Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 04:35 PM

RE: Tightening a 3-Jaw Chuck - by stevec - 01-24-2013, 05:08 PM

RE: Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 05:09 PM

RE: Tightening a 3-Jaw Chuck - by stevec - 01-24-2013, 05:14 PM

RE: Tightening a 3-Jaw Chuck - by f350ca - 01-24-2013, 05:30 PM

RE: Tightening a 3-Jaw Chuck - by sasquatch - 01-24-2013, 05:30 PM

RE: Tightening a 3-Jaw Chuck - by doubleboost - 01-24-2013, 05:39 PM

RE: Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 05:43 PM

RE: Tightening a 3-Jaw Chuck - by Mayhem - 01-24-2013, 06:09 PM

RE: Tightening a 3-Jaw Chuck - by PixMan - 01-24-2013, 06:28 PM

RE: Tightening a 3-Jaw Chuck - by Mayhem - 01-24-2013, 06:39 PM

RE: Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 06:40 PM

RE: Tightening a 3-Jaw Chuck - by Tony Wells - 01-24-2013, 07:50 PM

RE: Tightening a 3-Jaw Chuck - by Highpower - 01-24-2013, 10:19 PM

RE: Tightening a 3-Jaw Chuck - by Sunset Machine - 01-24-2013, 08:31 PM

RE: Tightening a 3-Jaw Chuck - by PixMan - 01-24-2013, 10:28 PM

RE: Tightening a 3-Jaw Chuck - by Highpower - 01-24-2013, 11:12 PM

RE: Tightening a 3-Jaw Chuck - by krv3000 - 01-25-2013, 04:27 PM

Users browsing this thread: 2 Guest(s)