The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Tightening a 3-Jaw Chuck

Thread Modes
Tightening a 3-Jaw Chuck
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#1
Question  01-24-2013, 01:38 PM
What's considered the proper way to tighten a 3-jaw chuck. I've heard differing opinions.

1. Always tighten using one jaw, the same one, every time.
2. Tighten using all three evenly.
3. It doesn't matter.

Thanks,
Ed
Reply
Thanks given by:


Messages In This Thread
Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 01:38 PM
RE: Tightening a 3-Jaw Chuck - by Highpower - 01-24-2013, 02:18 PM
RE: Tightening a 3-Jaw Chuck - by stevec - 01-24-2013, 02:47 PM
RE: Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 04:35 PM
RE: Tightening a 3-Jaw Chuck - by stevec - 01-24-2013, 05:08 PM
RE: Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 05:09 PM
RE: Tightening a 3-Jaw Chuck - by stevec - 01-24-2013, 05:14 PM
RE: Tightening a 3-Jaw Chuck - by f350ca - 01-24-2013, 05:30 PM
RE: Tightening a 3-Jaw Chuck - by sasquatch - 01-24-2013, 05:30 PM
RE: Tightening a 3-Jaw Chuck - by doubleboost - 01-24-2013, 05:39 PM
RE: Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 05:43 PM
RE: Tightening a 3-Jaw Chuck - by Mayhem - 01-24-2013, 06:09 PM
RE: Tightening a 3-Jaw Chuck - by PixMan - 01-24-2013, 06:28 PM
RE: Tightening a 3-Jaw Chuck - by Mayhem - 01-24-2013, 06:39 PM
RE: Tightening a 3-Jaw Chuck - by EdK - 01-24-2013, 06:40 PM
RE: Tightening a 3-Jaw Chuck - by Tony Wells - 01-24-2013, 07:50 PM
RE: Tightening a 3-Jaw Chuck - by Highpower - 01-24-2013, 10:19 PM
RE: Tightening a 3-Jaw Chuck - by Sunset Machine - 01-24-2013, 08:31 PM
RE: Tightening a 3-Jaw Chuck - by PixMan - 01-24-2013, 10:28 PM
RE: Tightening a 3-Jaw Chuck - by Highpower - 01-24-2013, 11:12 PM
RE: Tightening a 3-Jaw Chuck - by krv3000 - 01-25-2013, 04:27 PM



Users browsing this thread: 2 Guest(s)