The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › General Metalworking Discussion v
Dealing with cast iron / stress?

Thread Modes
Dealing with cast iron / stress?
Highpower Offline
JAFO
******
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#1
01-23-2013, 08:44 AM
Venturing into another new area for me... Blush

I have an iron casting here (camel back straight edge) that I want to attempt to turn into a usable tool. Angel

The raw casting has been fully annealed so that it will be machinable. After it is rough machined how does one determine if the casting needs to be thermally stress relieved? Or is that a given? 17428

I would hate to spend months hand scraping this thing only to have it twist into a pretzel later. Anyone been there / done that?
Willie
Reply
Thanks given by:


Messages In This Thread
Dealing with cast iron / stress? - by Highpower - 01-23-2013, 08:44 AM
RE: Dealing with cast iron / stress? - by PixMan - 01-23-2013, 10:23 PM
RE: Dealing with cast iron / stress? - by PixMan - 01-24-2013, 06:30 PM
RE: Dealing with cast iron / stress? - by claudef - 01-26-2013, 09:13 AM
Planers - by Sunset Machine - 01-26-2013, 09:48 AM
RE: Dealing with cast iron / stress? - by PixMan - 01-27-2013, 03:06 PM
RE: Dealing with cast iron / stress? - by EdK - 01-28-2013, 10:30 AM



Users browsing this thread: 1 Guest(s)