MetalworkingFun Forum › Machining › General Metalworking Discussion v
Chinese ???

Thread Modes
Chinese ???
Sunset Machine Offline
Junior
****
Posts: 716
Threads: 32
Joined: Apr 2012
Location: Washington, USA
#10
01-18-2013, 09:24 AM
Well, sounds like a wider, deeper trough is needed to make the error negligible. Reminds me of a neighbor lady who overfilled her car's engine with oil and was trying to draw it down by repeatedly wiping the dipstick clean... <chuckle>
Reply
Thanks given by:


Messages In This Thread
Chinese ??? - by ieezitin - 01-14-2013, 07:45 PM
RE: Chinese ??? - by f350ca - 01-14-2013, 07:57 PM
RE: Chinese ??? - by TomG - 01-14-2013, 08:25 PM
RE: Chinese ???. - by Sunset Machine - 01-15-2013, 08:29 AM
RE: Chinese ??? - by TomG - 01-15-2013, 11:40 AM
RE: Chinese ??? - by Sunset Machine - 01-16-2013, 09:22 AM
RE: Chinese ??? - by TomG - 01-16-2013, 09:45 AM
RE: Chinese ??? - by Sunset Machine - 01-17-2013, 08:52 AM
RE: Chinese ??? - by TomG - 01-17-2013, 10:27 AM
RE: Chinese ??? - by Sunset Machine - 01-18-2013, 09:24 AM
RE: Chinese ??? - by EdK - 01-18-2013, 09:51 AM
RE: Chinese ??? - by Highpower - 01-18-2013, 10:53 AM
RE: Chinese ??? - by EdK - 01-18-2013, 12:36 PM
RE: Chinese ??? - by ieezitin - 01-19-2013, 12:08 PM
RE: Chinese ??? - by Highpower - 01-19-2013, 12:27 PM
RE: Chinese ??? - by Sunset Machine - 01-19-2013, 01:06 PM
RE: Chinese ??? - by ieezitin - 01-20-2013, 10:19 AM
RE: Chinese ??? - by ieezitin - 01-20-2013, 10:59 AM
RE: Chinese ??? - by Mayhem - 01-18-2013, 11:01 AM
RE: Chinese ??? - by stevec - 01-18-2013, 12:15 PM
RE: Chinese ??? - by Highpower - 01-18-2013, 12:32 PM
RE: Chinese ??? - by stevec - 01-18-2013, 04:52 PM
RE: Chinese ??? - by f350ca - 01-20-2013, 11:00 AM
RE: Chinese ??? - by ieezitin - 01-20-2013, 11:38 AM
RE: Chinese ??? - by f350ca - 01-20-2013, 02:46 PM
RE: Chinese ??? - by TomG - 01-20-2013, 03:57 PM



Users browsing this thread: 5 Guest(s)