01-17-2013, 09:38 AM
Re: Pics of the buffer:
This is just an old electric motor i cleaned up, made a mount for it, installed a switch on it, then an arbour with the buffing pads .
The arbour is made out of older ski-doo axles, they are 1in diam, with a 1/2 hole through them , which makes a 1/4inch wall. Perfect to cut to length, then simply install a length of 1/2 in bolt into the center, drill and roll pin it, then tap the other end for a couple of set screws.
Just a simple basic setup.
This is just an old electric motor i cleaned up, made a mount for it, installed a switch on it, then an arbour with the buffing pads .
The arbour is made out of older ski-doo axles, they are 1in diam, with a 1/2 hole through them , which makes a 1/4inch wall. Perfect to cut to length, then simply install a length of 1/2 in bolt into the center, drill and roll pin it, then tap the other end for a couple of set screws.
Just a simple basic setup.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.