|
Chinese ???
|
Anrhony, you should be able to recalibrate it your self. Use the lathe bed, check the level then rotate it 180 degrees. Adjust the vial to split the readings. Continue till it reads the same as you rotate it. Then start adjusting the lathe to level. As you get the lathe close to level you may have to readjust the vial. By turning the level 180 you self calibrate it.
Free advice is worth exactly what you payed for it.
Greg |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Chinese ??? - by ieezitin - 01-14-2013, 07:45 PM
RE: Chinese ??? - by f350ca - 01-14-2013, 07:57 PM
RE: Chinese ??? - by TomG - 01-14-2013, 08:25 PM
RE: Chinese ???. - by Sunset Machine - 01-15-2013, 08:29 AM
RE: Chinese ??? - by TomG - 01-15-2013, 11:40 AM
RE: Chinese ??? - by Sunset Machine - 01-16-2013, 09:22 AM
RE: Chinese ??? - by TomG - 01-16-2013, 09:45 AM
RE: Chinese ??? - by Sunset Machine - 01-17-2013, 08:52 AM
RE: Chinese ??? - by TomG - 01-17-2013, 10:27 AM
RE: Chinese ??? - by Sunset Machine - 01-18-2013, 09:24 AM
RE: Chinese ??? - by EdK - 01-18-2013, 09:51 AM
RE: Chinese ??? - by Highpower - 01-18-2013, 10:53 AM
RE: Chinese ??? - by EdK - 01-18-2013, 12:36 PM
RE: Chinese ??? - by ieezitin - 01-19-2013, 12:08 PM
RE: Chinese ??? - by Highpower - 01-19-2013, 12:27 PM
RE: Chinese ??? - by Sunset Machine - 01-19-2013, 01:06 PM
RE: Chinese ??? - by ieezitin - 01-20-2013, 10:19 AM
RE: Chinese ??? - by ieezitin - 01-20-2013, 10:59 AM
RE: Chinese ??? - by Mayhem - 01-18-2013, 11:01 AM
RE: Chinese ??? - by stevec - 01-18-2013, 12:15 PM
RE: Chinese ??? - by Highpower - 01-18-2013, 12:32 PM
RE: Chinese ??? - by stevec - 01-18-2013, 04:52 PM
RE: Chinese ??? - by f350ca - 01-20-2013, 11:00 AM
RE: Chinese ??? - by ieezitin - 01-20-2013, 11:38 AM
RE: Chinese ??? - by f350ca - 01-20-2013, 02:46 PM
RE: Chinese ??? - by TomG - 01-20-2013, 03:57 PM
|
