removing arbor from chuck

[crankshafter]

(01-13-2013, 08:43 PM)mikecwik Wrote: The more gradual taper of the double Jacobs wedges in my opinion is more desirable than a single ball joint tool or even two ball joint tools from opposite sides.

Hi all.
I could have made a pair of wedges, but drilling thrue the body of the chuck was the easyest way
Since it's a Rohm$$ chuck with solid body, it's no way to reach the taper.
krv3000: Yes I could have cut the arbor and drill/ bore out the taper, did it last time I had to change taper on an other chuck.
But the way I did it this time I rescued a MT4 B16 chuck arbor.BTW: the chuck is doing well
Best reg:
CS. in freeazing cold Norway