|
Setting up a ball turning attachment
|
The key to getting a round ball is to have the center of rotation of the turning attachment right on center of the part in both directions. i.e. right along the axis of the turning, and halfway along the part (same as radius).
Adjust the tool as necessary.
Full of ideas, but slow to produce parts
Thanks given by: ml_woy
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Setting up a ball turning attachment - by ml_woy - 01-10-2013, 07:52 PM
RE: Setting up a ball turning attachment - by f350ca - 01-10-2013, 08:30 PM
RE: Setting up a ball turning attachment - by rleete - 01-11-2013, 12:34 PM
RE: Setting up a ball turning attachment - by Arbalest - 01-11-2013, 04:29 PM
RE: Setting up a ball turning attachment - by ml_woy - 01-13-2013, 11:17 AM
|
