|
plasma cutting tank
|
01-11-2013, 08:06 AM
(01-10-2013, 08:07 PM)stevec Wrote: I didn't think the water table was required for stuff under 3/8"? I'm interested in cutting down the smoke and fumes, especially for stainless! I got a bad head ache cutting stainless this summer! Can't be good for you! Regards, Matthew
mattinker, proud to be a member of MetalworkingFun Forum since Jan 2013.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
plasma cutting tank - by mattinker - 01-10-2013, 04:31 PM
RE: plasma cutting tank - by f350ca - 01-10-2013, 07:08 PM
RE: plasma cutting tank - by mattinker - 01-10-2013, 07:51 PM
RE: plasma cutting tank - by stevec - 01-10-2013, 08:07 PM
RE: plasma cutting tank - by mattinker - 01-11-2013, 08:06 AM
RE: plasma cutting tank - by f350ca - 01-10-2013, 08:09 PM
RE: plasma cutting tank - by dallen - 01-10-2013, 10:16 PM
RE: plasma cutting tank - by Highpower - 01-11-2013, 09:16 AM
RE: plasma cutting tank - by mattinker - 01-11-2013, 01:55 PM
|
