MetalworkingFun Forum › Machining › Projects v
Big Lathe Faceplate Project

Thread Modes
Big Lathe Faceplate Project
EdK Online
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#4
03-26-2012, 05:54 PM
(03-26-2012, 05:33 PM)aametalmaster Wrote: Check out the way i turned the OD with the boring bar...Bob

Bob,

I've seen that technique used before. Sometimes it's the only way to turn the OD on something that is really too big for the lathe. Nice job. Smile

Ed
Reply
Thanks given by:


Messages In This Thread
Big Lathe Faceplate Project - by aametalmaster - 03-26-2012, 05:31 PM
RE: Big Lathe Faceplate Project - by EdK - 03-26-2012, 05:54 PM
RE: Big Lathe Faceplate Project - by dallen - 07-20-2012, 03:39 PM
RE: Big Lathe Faceplate Project - by TomG - 07-21-2012, 08:52 PM
RE: Big Lathe Faceplate Project - by DaveH - 03-26-2012, 08:28 PM
RE: Big Lathe Faceplate Project - by Mayhem - 03-26-2012, 11:42 PM
RE: Big Lathe Faceplate Project - by doubleboost - 07-20-2012, 02:53 PM
RE: Big Lathe Faceplate Project - by krv3000 - 07-21-2012, 02:54 PM
RE: Big Lathe Faceplate Project - by Bill Gruby - 07-21-2012, 03:07 PM
RE: Big Lathe Faceplate Project - by EdK - 07-21-2012, 03:30 PM



Users browsing this thread: 2 Guest(s)