01-08-2013, 07:58 AM
The biggest reason for parting inserts to fail is too low of a feed rate. They like to be pushed. If the insert is 3mm or 1/8" wide, you should be feeding at least .003" per rev, though .005-.008 is even better.
|
Mystery cut-off tool holder
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mystery cut-off tool holder - by Highpower - 01-03-2013, 10:09 PM
RE: Mystery cut-off tool holder - by sasquatch - 01-03-2013, 10:40 PM
RE: Mystery cut-off tool holder - by PixMan - 01-04-2013, 07:31 AM
RE: Mystery cut-off tool holder - by stevec - 01-04-2013, 08:46 AM
RE: Mystery cut-off tool holder - by Highpower - 01-04-2013, 10:17 AM
RE: Mystery cut-off tool holder - by EdK - 01-04-2013, 12:35 PM
RE: Mystery cut-off tool holder - by dallen - 01-04-2013, 12:41 PM
RE: Mystery cut-off tool holder - by PixMan - 01-04-2013, 09:12 PM
RE: Mystery cut-off tool holder - by Highpower - 01-05-2013, 08:01 AM
RE: Mystery cut-off tool holder - by PixMan - 01-05-2013, 08:24 AM
RE: Mystery cut-off tool holder - by Highpower - 01-07-2013, 11:35 PM
RE: Mystery cut-off tool holder - by PixMan - 01-08-2013, 07:58 AM
RE: Mystery cut-off tool holder - by Highpower - 01-08-2013, 09:21 AM
|
Users browsing this thread: 4 Guest(s)