|
Mystery cut-off tool holder
|
01-04-2013, 12:41 PM
cut a dovetail in them that will fit the tool post and use them, I have several 1 inch shanks that I have done that way or just mill em down so they fit in the holder with the insert at proper height.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Mystery cut-off tool holder - by Highpower - 01-03-2013, 10:09 PM
RE: Mystery cut-off tool holder - by sasquatch - 01-03-2013, 10:40 PM
RE: Mystery cut-off tool holder - by PixMan - 01-04-2013, 07:31 AM
RE: Mystery cut-off tool holder - by stevec - 01-04-2013, 08:46 AM
RE: Mystery cut-off tool holder - by Highpower - 01-04-2013, 10:17 AM
RE: Mystery cut-off tool holder - by EdK - 01-04-2013, 12:35 PM
RE: Mystery cut-off tool holder - by dallen - 01-04-2013, 12:41 PM
RE: Mystery cut-off tool holder - by PixMan - 01-04-2013, 09:12 PM
RE: Mystery cut-off tool holder - by Highpower - 01-05-2013, 08:01 AM
RE: Mystery cut-off tool holder - by PixMan - 01-05-2013, 08:24 AM
RE: Mystery cut-off tool holder - by Highpower - 01-07-2013, 11:35 PM
RE: Mystery cut-off tool holder - by PixMan - 01-08-2013, 07:58 AM
RE: Mystery cut-off tool holder - by Highpower - 01-08-2013, 09:21 AM
|
