01-04-2013, 10:17 AM
Well I guess they don't exist then since I don't have them in front of me.
A friend of a friend was looking for a new home for them, and asking if anybody wanted them. The story is they came in unmarked packaging from McMaster-Carr (no surprise) and no identifying markings other than engraved part numbers on the tools.
I'll see if I can get some measurements through the grapevine, but as I only have AXA and BXA tool posts, if the holder is 3/4" it would be too large for my lathe anyway. Just my luck...
A friend of a friend was looking for a new home for them, and asking if anybody wanted them. The story is they came in unmarked packaging from McMaster-Carr (no surprise) and no identifying markings other than engraved part numbers on the tools.
I'll see if I can get some measurements through the grapevine, but as I only have AXA and BXA tool posts, if the holder is 3/4" it would be too large for my lathe anyway. Just my luck...
Willie