MetalworkingFun Forum › Machining › General Metalworking Discussion v
What Size Drill and Tap To Use?

Thread Modes
What Size Drill and Tap To Use?
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#11
01-04-2013, 06:08 AM
ml,
I think 2.2mm is a touch on the small size. Go with PixMan or if you want metric 3 or 3.5mm thread.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
What Size Drill and Tap To Use? - by ml_woy - 01-02-2013, 08:45 PM
RE: What Size Drill and Tap To Use? - by PixMan - 01-02-2013, 09:15 PM
RE: What Size Drill and Tap To Use? - by ml_woy - 01-03-2013, 10:05 AM
RE: What Size Drill and Tap To Use? - by EdK - 01-04-2013, 08:46 AM
RE: What Size Drill and Tap To Use? - by Arbalest - 01-03-2013, 01:18 PM
RE: What Size Drill and Tap To Use? - by EdK - 01-03-2013, 01:37 PM
RE: What Size Drill and Tap To Use? - by Arbalest - 01-03-2013, 03:29 PM
RE: What Size Drill and Tap To Use? - by stevec - 01-03-2013, 04:40 PM
RE: What Size Drill and Tap To Use? - by Arbalest - 01-03-2013, 05:31 PM
RE: What Size Drill and Tap To Use? - by PixMan - 01-03-2013, 07:38 PM
RE: What Size Drill and Tap To Use? - by DaveH - 01-04-2013, 06:08 AM
RE: What Size Drill and Tap To Use? - by f350ca - 01-04-2013, 09:53 AM
RE: What Size Drill and Tap To Use? - by stevec - 01-04-2013, 08:02 PM
RE: What Size Drill and Tap To Use? - by f350ca - 01-04-2013, 10:15 PM



Users browsing this thread: 1 Guest(s)