What Size Drill and Tap To Use?

Hello There, Guest! Register

Thread Modes

What Size Drill and Tap To Use?

Arbalest Offline

Offline

Sophmore

Posts: 175
Threads: 4
Joined: Sep 2012
Location: Dorset, UK

#6

01-03-2013, 03:29 PM

Thanks Ed. like some other folks I fitted a ball race between the two major parts to make it nice and smooth in use.

Arbalest, proud to be a member of MetalworkingFun since Sep 2012.

Reply

« Next Oldest | Next Newest »

Messages In This Thread

What Size Drill and Tap To Use? - by ml_woy - 01-02-2013, 08:45 PM

RE: What Size Drill and Tap To Use? - by PixMan - 01-02-2013, 09:15 PM

RE: What Size Drill and Tap To Use? - by ml_woy - 01-03-2013, 10:05 AM

RE: What Size Drill and Tap To Use? - by EdK - 01-04-2013, 08:46 AM

RE: What Size Drill and Tap To Use? - by Arbalest - 01-03-2013, 01:18 PM

RE: What Size Drill and Tap To Use? - by EdK - 01-03-2013, 01:37 PM

RE: What Size Drill and Tap To Use? - by Arbalest - 01-03-2013, 03:29 PM

RE: What Size Drill and Tap To Use? - by stevec - 01-03-2013, 04:40 PM

RE: What Size Drill and Tap To Use? - by Arbalest - 01-03-2013, 05:31 PM

RE: What Size Drill and Tap To Use? - by PixMan - 01-03-2013, 07:38 PM

RE: What Size Drill and Tap To Use? - by sasquatch - 01-03-2013, 08:51 PM

RE: What Size Drill and Tap To Use? - by DaveH - 01-04-2013, 06:08 AM

RE: What Size Drill and Tap To Use? - by f350ca - 01-04-2013, 09:53 AM

RE: What Size Drill and Tap To Use? - by stevec - 01-04-2013, 08:02 PM

RE: What Size Drill and Tap To Use? - by f350ca - 01-04-2013, 10:15 PM

Users browsing this thread: 2 Guest(s)