MetalworkingFun Forum › Machining › General Metalworking Discussion v
What Size Drill and Tap To Use?

Thread Modes
What Size Drill and Tap To Use?
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#5
01-03-2013, 01:37 PM
(01-03-2013, 01:18 PM)Arbalest Wrote: I used a countersunk screw with the head turned down a little on mine.

For this particular insert I used M4.

Very nice ball turner. Thumbsup

Ed
Reply
Thanks given by:


Messages In This Thread
What Size Drill and Tap To Use? - by ml_woy - 01-02-2013, 08:45 PM
RE: What Size Drill and Tap To Use? - by PixMan - 01-02-2013, 09:15 PM
RE: What Size Drill and Tap To Use? - by ml_woy - 01-03-2013, 10:05 AM
RE: What Size Drill and Tap To Use? - by EdK - 01-04-2013, 08:46 AM
RE: What Size Drill and Tap To Use? - by Arbalest - 01-03-2013, 01:18 PM
RE: What Size Drill and Tap To Use? - by EdK - 01-03-2013, 01:37 PM
RE: What Size Drill and Tap To Use? - by Arbalest - 01-03-2013, 03:29 PM
RE: What Size Drill and Tap To Use? - by stevec - 01-03-2013, 04:40 PM
RE: What Size Drill and Tap To Use? - by Arbalest - 01-03-2013, 05:31 PM
RE: What Size Drill and Tap To Use? - by PixMan - 01-03-2013, 07:38 PM
RE: What Size Drill and Tap To Use? - by DaveH - 01-04-2013, 06:08 AM
RE: What Size Drill and Tap To Use? - by f350ca - 01-04-2013, 09:53 AM
RE: What Size Drill and Tap To Use? - by stevec - 01-04-2013, 08:02 PM
RE: What Size Drill and Tap To Use? - by f350ca - 01-04-2013, 10:15 PM



Users browsing this thread: 2 Guest(s)