01-03-2013, 07:31 AM
OK, so the diameter on these are listed as 0.1000". How much smaller should I drill the hole? Is a #40 drill (0.0980") going to be too tight? Either side is 0.0960" and 0.0995"
This is to reattach the name plates on my mill, so it will be going into cast aluminium on some parts and cast iron on others. I'll mic the drive screws before I start drilling, just to make sure they are 0.1000"
This is to reattach the name plates on my mill, so it will be going into cast aluminium on some parts and cast iron on others. I'll mic the drive screws before I start drilling, just to make sure they are 0.1000"
Hunting American dentists since 2015.