Johnson Model B bandsaw

[monkers]

ok, got a little more done the other day, made up some base plates for casters and welded them on, made a new lower spring mount and welded it on, welded some stray holes closed that I didnt need, and welded up the stray cuts in the table where the blade comes down. My saw has a small recess on the inboard side of the out feed table, so I just touched that up a little where some cuts had gone wild, and I welded the out board side, it needed a lot of build up, then ground it all down. Not overly excited about the results, better than it was but not perfect. It also does not look as bad in person as it does in the photos. I also made a bracket to add a lower shelf for small cut offs, the rear angle (on the back legs) was welded on with a 1/4" difference from side to side, I didnt have a good way to get in there and cut out the old weld so I left it . I will add a piece of plywood to it when the saw is done. Then I started cleaning up parts and getting ready for some paint.....hope to get more time to work on it soon.