12-19-2012, 05:57 PM
Their pricey on their stuff, and I have ordered from them but they don't have .5 diameter rolls, not that I can't get by with something a little larger say .625 and cut a recess in the frame so they will open up, but it would be nice to get the full capacity of the tool, not that I do much knurling over half an inch but you never know.
I purchased the bolts that I needed for the locking screws and adjuster this morning then I turned the ends flat and turned the thread off so that the locking screws would not mar the top or end up with mushroomed ends, I also cut a slot in the top of the arms when I made them.
DA
I purchased the bolts that I needed for the locking screws and adjuster this morning then I turned the ends flat and turned the thread off so that the locking screws would not mar the top or end up with mushroomed ends, I also cut a slot in the top of the arms when I made them.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!