MetalworkingFun Forum › Machining › Projects v
Taper Attachment home made.

Thread Modes
Taper Attachment home made.
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#6
03-23-2012, 08:36 PM
(03-23-2012, 08:24 PM)ETC57 Wrote: I have a question regarding the mounting of a taper attachment and my smithy. It appears that the device attaches to the way on the back side of the lathe? if that is the case how would I go about installing one on my smithy? It has dove tail ways.





Jerry.Popcorn

You could drill and tap a hole on the end of your 3 in 1 combo i assume? for the bracket. The harder part would be removing the cross slide screw so the compound floats on the sine bar...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:


Messages In This Thread
Taper Attachment home made. - by aametalmaster - 03-23-2012, 07:47 PM
RE: Taper Attachment home made. - by EdK - 03-23-2012, 08:11 PM
RE: Taper Attachment home made. - by ETC57 - 03-23-2012, 08:24 PM
RE: Taper Attachment home made. - by aametalmaster - 03-23-2012, 08:36 PM
RE: Taper Attachment home made. - by EdK - 03-23-2012, 08:32 PM
RE: Taper Attachment home made. - by ETC57 - 03-23-2012, 08:37 PM
RE: Taper Attachment home made. - by ETC57 - 03-23-2012, 08:41 PM
RE: Taper Attachment home made. - by DaveH - 03-24-2012, 08:10 AM



Users browsing this thread: 2 Guest(s)