|
Taper Attachment home made.
|
03-23-2012, 08:24 PM
I have a question regarding the mounting of a taper attachment and my smithy. It appears that the device attaches to the way on the back side of the lathe? if that is the case how would I go about installing one on my smithy? It has dove tail ways.
Jerry. 
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Taper Attachment home made. - by aametalmaster - 03-23-2012, 07:47 PM
RE: Taper Attachment home made. - by aametalmaster - 03-23-2012, 07:51 PM
RE: Taper Attachment home made. - by EdK - 03-23-2012, 08:11 PM
RE: Taper Attachment home made. - by aametalmaster - 03-23-2012, 08:38 PM
RE: Taper Attachment home made. - by ETC57 - 03-23-2012, 08:24 PM
RE: Taper Attachment home made. - by aametalmaster - 03-23-2012, 08:36 PM
RE: Taper Attachment home made. - by EdK - 03-23-2012, 08:32 PM
RE: Taper Attachment home made. - by ETC57 - 03-23-2012, 08:37 PM
RE: Taper Attachment home made. - by ETC57 - 03-23-2012, 08:41 PM
RE: Taper Attachment home made. - by DaveH - 03-24-2012, 08:10 AM
|
