12-15-2012, 08:58 AM
Finally got around to making some pseudo T-nuts for my welding bench. The reason I say pseudo is that I didn't thread them, as initially I was going to weld a stud to base of the two toggle clamps I have, so I can also use them on my drill press. Then I realized that if I did that, I couldn't use them on my mill. So, they will be used with a bolt and a wing nut.
The two square plates will be used with the T's to allow other items to be bolted down to the table or with a bolt and two nuts to provide support.
Nothing special, all bits out of the scrap box
The two square plates will be used with the T's to allow other items to be bolted down to the table or with a bolt and two nuts to provide support.
Nothing special, all bits out of the scrap box
Hunting American dentists since 2015.