03-23-2012, 05:47 PM
That's my back up plan, use a Dremel with a cut-off disk.
I finally got that snap ring out, what a difference a quality tool makes.
So I was able to knock out the last shaft that was still in the head. To my surprise there was a bearing attached to it that I couldn't see because the large gear was blocking it. So now I'll be short one of the 6007 bearings. Oh well, I still have to order the tapered roller bearings yet anyway.
Anybody know a good place to get P/6 tapered roller bearings? I've been searching most of the afternoon with no luck. I found some P/5s but don't want to spend that kind of money since it's overkill for this mill.
Ed
I finally got that snap ring out, what a difference a quality tool makes.
So I was able to knock out the last shaft that was still in the head. To my surprise there was a bearing attached to it that I couldn't see because the large gear was blocking it. So now I'll be short one of the 6007 bearings. Oh well, I still have to order the tapered roller bearings yet anyway.
Anybody know a good place to get P/6 tapered roller bearings? I've been searching most of the afternoon with no luck. I found some P/5s but don't want to spend that kind of money since it's overkill for this mill.
Ed