Fixing a Leaky RF-45 Mill Head - Enco

[TOM REED]

[quote='EdAK' pid='1558' dateline='1332516024']
I got the taper roller bearings out. I was hoping to reuse the original bearings because of the cost of new P/6 bearings but it looks like I'm going to have to spring for new bearings. I'm not liking what I see in the old bearings.

Ed

look a little rough, you will have to make sure the preload is st correctly on the new ones, I assume there is an adjustment for preload (usually always provided fo tapered rollers) tom